Double-threaded screw for fastening photovoltaic systems on roofs with a steel load-bearing structure covered by corrugated panels, faux panels or tiles.

Stud screw STSI A2

STSI is the double-threaded screw in A2 stainless steel for PV panels mounting on roofs with a steel load-bearing structure covered by corrugated panels, faux panels or tiles. Incorporated EPDM gasket for sealing against rain infiltration. Pre-drilling required.

Варианти на продуктите

Download of image data

Варианти на продуктите

2 Варианти на продукта

Length

Steel thread length

Metric thread length

Thread

Diameter

Width across nut

Разгледан(и) 2 от 2 вариант(а)

Functionality

Determine the centre distance of the STSI double-threaded screws according to the snow and wind loads of the system installation area and inclination of the roof.
Identify the position of the STSI double-threaded screws depending on the load-bearing structure and the layout of the installation (use SOLARPANEL-FiX for the design).
Drill the support according to the diameter of the screw.
Tighten the STSI double-threaded screw until the gasket is fully in contact with the roof covering.
Carefully seal the exit point of the screw from the roof with bituminous sealant in order to improve waterproofness.
Connect the Solar rail to the upper part of the screw by inserting SSP or MW connection plates, adjusting their height using the MU nuts.

Mounting Strip 1 Picture

1 / 6

Length ( l )	181 mm
Steel thread length ( l₁ )	70 mm
Metric thread length	50 mm
Thread ( M )	M10
Diameter ( d )	8 mm
Width across nut	13 mm
Width across nut ( SW₁ )	5 mm
Amount	10 pcs
GTIN (EAN-Code)	8001132046456

Length ( l )	256 mm
Steel thread length ( l₁ )	70 mm
Metric thread length	50 mm
Thread ( M )	M10
Diameter ( d )	8 mm
Width across nut	13 mm
Width across nut ( SW₁ )	5 mm
Amount	10 pcs
GTIN (EAN-Code)	8001132046470

Stud screw STSI A2

Варианти на продуктите

Предимства / Описание на продукта

Приложение и одобрение

Инструкции за монтаж

Документи за изтегляне